When it comes to plasma cutters, not everyone can afford them. If you’re looking for the best deal on cutters and want to buy plasma cutters for a low price, you need to know what to look out for when shopping for your next purchase. The first thing that you should look out for is whether or not the Best Plasma cutters under 1000 dollars. Cutting costs can go up as you go up in price but keep in mind that even if the cost goes up, the quality may increase or decrease depending on the store you purchase from and the company that makes the cutters.
There are two types of cutters that you can get: electrical and gas. If you have websites that have electrical power, you will need to find cutters with at least a three thousand watt rating so that you can cut through thicker sheets of wood. Gas cutters are usually only capable of cutting smaller pieces. You can get both kinds but it’s important to choose your type based on your needs. Some small websites may not require the strength that gas cutters bring so it might be cheaper to buy an electrical cutter and use that exclusively. However, if you have larger websites where more weight needs to be removed from the surface, gas cutters are ideal.
Another thing that you need to look for is whether or not the plasma cutter is compatible with the welding equipment that you have. For example, if you weld aluminum and need a strong cutting tool, the welders won’t work. Also, many of the websites that I work in have only electric tools so any cutting tools that use gasoline are not going to be able to get the job done. It’s also important to look for the level of voltage support. You may be able to get cutters that have the highest level of voltage support, but they’re also going to be the most expensive.
Higher priced units will give you more capabilities and they’ll last longer but you should still be looking at the overall cost vs. the duty cycle. The duty cycle is how many times the tool has been used in a day and will determine its price. Plasma cutters with a long duty cycle will perform better and will save you money over time. A tool that only lasts a day or two should never be purchased.
Finally you need to look for the style of plasma cutter. There are basically two different types: those that carry handles while welding and those that don’t. If you’re welding a very small piece, it may not be necessary to carry a heavy cutter around all day but for larger jobs it’s advisable. If you know what you’re doing, a tool with a carry handle will make it much easier to operate because it won’t be as intimidating to hold.
Another thing that can help determine prices is the size of the cutter. We’re talking about big machines here to get one that is a bit smaller than you think you’ll need is a bad idea. The best cutters come in between one hundred sixty to one hundred eighty dollars. Anything over one hundred dollars and you’re probably going to be wasting your money. Bigger units tend to cut thicker metals, which means that you’re not going to get the results you want with thinner metals. If you plan on welding aluminum, stainless steel, or copper then the smaller multi-bladed cutters might be best.
Blunt cutters are great for cleaning up the mess caused by welding and cutting. If you’re buying a bladed torch for this job, then you want one that uses carbon dioxide to burn the impurities off of the metals before they touch your welded up joint. Clean cutters use a jet of compressed air to blast away these impurities, which helps remove both flake and rust buildup. The clean cutters usually cost between seventy-five to one hundred and fifty dollars.
The last thing that will help you decide on what kind of plasma cutters to buy when looking for a good bargain is whether you want a gas or an electric model. Gas models use a small amount of propane, which means that they don’t put out as much heat but they do throw out a lot of exhaust so you need to make sure that your home is not near any other livelier area. Electric cutters are much cheaper to run because they use a small amount of electricity to power the fan and motor. The fan can be set to run at a lower speed if your working area is not that heavily trafficked. I personally like the gas models because they are more portable, easier to clean up after, and much safer to use than the electric models.